Vacuum area. Dilute the Deep Cleaner provided in the kit in a spray bottle with water as directed on bottle. Spray cleaner on tile and grout, allow to sit for 2 to 3 minutes. Work the deep cleaner back and forth lightly with any standard scrub brush to loosen dirt and open the grout pours. Wipe away dirt and excess cleaner with a towel. Do not apply the grout sealer over puddling liquid, you can start the color seal over the moisture in the grout from the cleaning process. The grout lines do not need to be stain free just dirt free and toweled dried. Shake color seal well before applying.
Apply a thin bead of Coat of Armor Grout Solutions tile grout sealer in the middle of the grout joint in one direction across the area at a time (apply in a North to South pattern across the area wiping excess color seal off each tile completing the process for each joint before moving to the next tile then apply from East to West, this allows the first direction to set before crossing over the joint in the opposite direction). Use the grout brush provided in the kit to spread the sealer working it back and forth so the entire grout joint is covered well. Within a few minutes use a damp chamois to remove the excess grout color sealer from the tile rinsing it often in a clean bucket of water. Fold the chamois and wipe with a soft hand over the tile without hitting the grout leaving the color seal to dry in the grout line. If the grout lines are flush with the tile wipe down both sides of the grout joint, one side at a time to remove it off the tile leaving it in the grout line. Repeat over entire area.
The joint will be dry to the touch in 20 min. In 2 hours it will be completely dry and any excess residue on the tile can be removed with glass cleaner. After 2 hours pets can enter the area. Do not wash floor or use shower for 36 hours.
MAINTAIN YOUR NEW COLOR SEAL OR CLEAR SEAL AND TILE WITH A STEAM MOP OR NON ACIDIC CLEANSER. NO HARSH CHEMICALS.
COAT OF ARMOR GROUT SOLUTIONS MAINTENANCE CLEANER IS RECOMMENDED.